Robot Actuators: Motor, Gearbox and Feedback
See how the motor, gearbox and feedback sensors work together in a robot joint, from torque and speed to measured output position.
Read More
Resolver and Encoder Compatibility with Servo Drives
Check feedback interfaces, wiring and commissioning conditions when matching a resolver or encoder to a servo motor and drive.
Read More
LVT and HVT Torque Motors: Supply and Load Profile
Repeated stops and loaded dwells put different demands on a motor. Use the available power supply, the torque–speed profile and the mounting drawing to compare LVT and HVT options.
Read More
Frameless or Housed Servo Motor: An OEM Checklist
Frameless and housed servo motors bring different installation work to the same axis. A practical look at mechanical layout, heat transfer, drive interfaces and production.
Read More
Mechanical and Thermal Checks for Frameless Motor Integration
Review bearings, centring, air gap and heat transfer before integrating a frameless motor. Prepare the technical information and prototype checks needed to discuss an FRM motor for your application.
Read More
AGV Traction Motor Selection
Selecting an AGV drive unit does not start with a catalogue power rating. This guide covers a worked torque calculation, the traction check most projects skip, and the architecture decision.
Read More
What Is a Resolver?
A resolver is an analogue position sensor that measures shaft angle electromagnetically. With no electronics inside, it works where an encoder cannot.
Read More
BLDC Servo Motor Selection
Motor selection in battery-powered systems cannot be made on wattage. This guide explains how high current on a 24V bus determines cable, connector and battery choice, how to compare the torque–speed points of the 13 LVS series models, and which 10 parameters to define before requesting a quotation.
Read More
What is a Torque Motor?
A torque motor transmits motion directly to the load without a gearbox or belt. This guide sets out the decision criteria, the total cost of ownership logic and the 8 parameters to define before requesting a quotation, for procurement and project managers deciding between a direct drive torque motor and a geared servo.
Read More

